how to attach a bike trailer to a bike

Bicycle trailers can turn bicycles into real carriages, from non-
The human goods behind the bike are given to young children.
It may be difficult at first glance, but installing a bike trailer on a bike can be done in a few simple steps.
Description difficulty: Use the wrench moderately to remove the nuts and washers that fix the rear wheel of the bicycle on the bicycle frame (
At the center of the wheel).
Put them in a safe place as you will use them again soon.
The axle of the bike should now stretch out the wheel with no nuts and washers.
Slide the tab washer onto the axle of the bike.
Turn it until it naturally fits into the frame of the bike.
Slide the hook plate onto the axle of the bike.
Install it in the hole of the label washer.
The big hole should be at the bottom, not at the top.
Put the washer and nut of the wheel back on the shaft and tighten--
First hand and then wrench.
Fix the tow bar of the bicycle trailer on the hook plate.
The tractor should slip through the big hole in the hook plate.
Your bike trailer should come with a pin or other fastening device;
Use this to fix the tractor on the hook plate.
The article written by William JacksonWilliam Jackson has been professionally written, reported and edited for more than 10 years.
His works have been published in newspapers, magazines, academic journals
Government reports, books and online levels.
He holds a master\'s degree in humanities from Penn State University.